10 |
Brass
Insert Fitting
Provides a connection between poly
pipe and pipe thread of Pitless Adapter. |
15 |
Drain
Valve
For easy draining of the system. |
20 |
SQUARE
D Safety Switch
for electric control and
distribution to the pump. |
11 |
Watertight
Well Cap
Inner gasket compresses to outside
diameter of casing to provide a watertight seal.
Top of cap removes easily to access well for
service. |
16 |
Brass
Nipple
Male threads allow attachment of
Pressure Switch to Tank Tee. |
21 |
Motor
Minder
Adjustable, solid state control that
monitors system load conditions to protect pump
motor from dry well, loss of flow, rapid cycling,
slow recovery, air lock, and locked rotor
problems. |
12 |
Well
Seal
Used in above-ground installations
to provide a positive seal inside casing. |
17 |
Relief
Valve
Protects against pressure buildup.
Should be used on any system where the pump could
develop greater pressure than the maximum rating
of the system. |
22 |
Lightning
Arrestor
Protects pump motor & controls
from voltage surges caused by lightning, switching
loads, and power line interference. |
13 |
Check
Valve
On pump installations, a Check Valve
installed near the tank inlet holds water in the
tank when the pump is idle. |
18 |
Pressure
Gauge
Measures water pressure in Pressure
Tank. |
23 |
Ball
Valve
Acts as a shutoff valve on the
supply line from the tank to the house. |
14 |
Tank
Tee
Connects water line from pump to
pressure tank and service line from tank to house.
Taps are provided to accept Pressure Switch,
Pressure Gauge, Drain Valve, Relief Valve, Snifter
Valve, etc. |
19
|
Pressure
Switch
Signals the pump to start when the
water system drops to a preset low pressure, and
to stop when the high pressure mark is reached. |
24
|
Water
Filter
A point-of-entry, whole-house
filter that removes rust particles, sand, etc.
from supply water.
|
This
illustration is not intended to be an installation
guide.
Check local codes for actual requirements
and restrictions.
|